back to top

MT Profil Tank Gauge

This easy to install water level gauge is suitable for installation on potable and rainwater tanks as well as some diesel and oil applications.  The gauge has a reversible faceplate. One side can be used for tanks to 1.5m in height, the other side for water tanks to 2.5m in height. This means that the gauge will give an accurate reading of the current water level in the tank. The gauge can be supplied with a flanged back nut that is screwed down onto the water tank.  The face diameter is 90mm.

The level gauge has a weighted float attached to it via a cord. The float is sufficiently weighted so that as the water level rises or falls, the pointer on the level gauge rotates to indicate the current water depth.

Depending on the height of the water tank, select the dial that will give you the best accuracy. Drill a 40mm hole into the tank and drop the float through it. Screw down the flange plate using two self tapping stainless steel screws. Adjust the dial by rotating it clock or anti-clockwise so that the maximum water depth is aligned with the red line on the dial faceplate.

 

Tank Level Gauge
Order Code	Description
3722205	Tank Level Gauge
3720001	Flange

MECA Tank Level Gauge

The MECA mechanical tank level gauge displays the depth of water in rainwater tanks, drums or any fluid container.  Suitable for tanks up to 2 metres deep.

The gauge can be mounted in minutes on the top of your tank using a flanged back nut, no batteries or wiring required.

The gauge comes with a 90mm easy to read dial face, which registers up to 200cm depth when your tank is full and zero when empty.

Calibration is easy and requires only the turn of a screw to adjust the dial for tank depths less than 200cm.

Tank Level Gauge
Order Code	Description
3720000	Tank Level Gauge
3720001	Flange

Televar Pneumatic Level Gauge

The TELEVAR Gauge is totally pneumatic in operation, suits tanks to 5 metres in depth and is suited to all types of compatible fluid. The large, readable dial (130mm scale) has a "tell tale" pointer to monitor water usage or rainfall collections, and can be supplied to suit a cylindrical tank either base or side mounted, as is common for gravity fed diesel tank storage "on farm". A sensor is dropped into the tank and a spring loaded plunger displaces fluid, measuring level using the bubbler principle.

The TELEVAR Gauge can be mounted up to 50 metres from the tank, above or below it, possibly inside a shed or the house - the point is that the indicator can be easily and regularly viewed so that you never run short again.

 back to top